|
Toy Trucker &
Contractor
|
|
|
Build A Fence Ridin’ Chevy
After installing the engine on the frame, it was time to do a little weathering. While the rest of the truck would be weathered much later on, I couldn't wait for the engine. Keep in mind that the last thing I wanted was an engine that looked like it just came out of the factory. I did slop a little dirty thinner onto the engine so that the stuff would work its way into all the nooks and crannies, but more was needed. Rather than try to simulate dirt and grime, I headed for my '93 Buick Roadmaster Estate Wagon...a real one, not a model. Popping the hood, I proceeded to get my hands dirty with actual engine dirt & grease, then came in the shop and did nothing more than simply handle the engine. You can see the results that are possible by checking out the photo above, as well as the one just below.
Incidentally, I didn't worry all that much about being careful about handling the model. Dust and grime from your hands goes a long way towards realism in this kind of a project. Just don't overdo it! Now it's on to the exhaust pipe/muffler.
The exhaust pipe/muffler was painted Model Master Steel, given a little natural weathering and installed. Before doing so, I used a pin vise to drill out the end of the pipe for a more realistic appearance. If you have the bad fortune for the drill bit to break out the side of the pipe, put a little rust on it to replicate a corroded exhaust pipe. As for the hubcaps, it doesn't take much time as a ranch workhorse for them to become missing in action. |
|
| Return to home page | |
|
|
|
